Curved Nozzle Kit #13925

The D/F Curved Nozzle Kit is readily adaptable to the Semi-Automatic MIG Water-Cooled Pistol Grip Gun to extend the Water-Cooled Nozzle for easy access to hard to reach weld locations. The optional Curved Nozzle Kit is available with a 55° nozzle that can be attached in place of the regular gas cup. The curved nozzle can be turned in any direction from the front of the torch. The kit is available with bent current tips accommodating a wire diameter range of .035"-1/16" for hard wire, and 3/64"-1/16" for aluminum wire.

D/F Curved Nozzle Kit #13925








REF. CODE NO. DESCRIPTION
1 10365 Curved Gas Nozzle
2 13926 Luck Nut
3 13927 Adapter
4
15065
Bent Current Tip .035” Hard
15062
Bent Current Tip .045” Hard
15063
Bent Current Tip 1/16” Hard
15072
Bent Current Tip 3/64” Aluminum
15073
Bent Current Tip 1/16” Aluminum
5
12116
Wrench

Installation

To adapt the Curved Nozzle, proceed as follows:
1. Remove the existing Gas Nozzle, Current Tip and Collet Nut from the Water-Cooled Nozzle.
2. Fasten the Adapter (13927) using the Wrench (12116) into the forward end of the Water-Cooled Nozzle.
3. Place the Collet Nut on the Bent Current Tip and tighten to provide access to welding condition desired.
4. Slide the Curved Nozzle (10365) over the Bent Current Tip until it engages in the Adapter. Fasten the curved end of the Curved Gas Nozzle by tightening the Lock Nut (13926). Observe the latter carefully so that the curved nozzle remains concentric to the Bent Current Tip.